1 HP Submersible Trash Pump, 115V for Pond Draining and Dewatering
The EasyPro ETP10N is a 1 HP, 115-volt submersible trash pump designed for draining ponds, reservoirs, flooded areas, and construction sites. It can pass solids up to a specified size, making it suitable for pumping dirty water, sediment-laden water, and light slurries that would damage a standard clean-water pump.
Pump Down Ponds and Reservoirs with Confidence
Seasonal pond draining, emergency dewatering, and waterfall feature winterisation all require a pump capable of handling debris-laden water without clogging. The ETP10N's trash-rated impeller and housing pass solids without binding, making it the right tool for pumping out a koi pond that contains leaves, algae, and sediment at the bottom. At 1 HP and 115V, it runs on standard household power and delivers the head pressure needed to move water across a garden to a drain or natural area.
| Specification | Value |
|---|---|
| Power | 1 HP |
| Voltage | 115V |
| Pump Type | Submersible trash / dewatering pump |
| Application | Pond draining, dewatering, slurry transfer |
| Installation | Fully submersible |
How to Use
Lower the pump to the lowest point of the pond or area to be drained. Connect a discharge hose and direct it to a suitable drainage point at least 10 ft (3 m) from the pond edge to prevent recirculation. Plug into a GFCI-protected 115V outlet and allow the pump to run until water level drops to the minimum operating depth. Do not run dry. Remove and rinse the pump after use in sediment-heavy applications.
Ideal for seasonal pond draining, emergency dewatering, construction site water removal, and any application where standard clean-water pumps would clog or fail.